Sub-Zero 601F Brochure & Specs

BUILT-IN REFRIGERATION
19
GLASSWELL PANEL OPTIONS
If you choose not to use custom wood panels
above or below the glasswell for Model 685 or
695 framed application, a stainless steel insert
panel will be provided with the partial framed
accessory kit. This accessory kit (FRAMPAR),
includes partial framed molding and classic
stainless steel inset handle panel to provide a
spill-resistant finish above and below the glass-
well on the refrigerator door only. Refer to the
Framed Panel Specifications for this option on
page 21.
With the framed retrofit accessory kit, existing
Model 680 or 690 door panels can be used on a
new Model 685 or 695 framed unit. This acces-
sory kit (FRAMRET) includes framed retrofit
moldings and classic stainless steel inset handle
panels to accommodate existing Model 680 or
690 framed refrigerator and freezer door panels.
IMPORTANT NOTE: When using Model 680 or
690 raised panels with the framed retrofit kit
(FRAMRET), a
1
/2" (13) trim reveal down to
1
/4"
(6) thickness is necessary at the bezel in order
for the panels to fit properly.
Both accessory kits are available through your
Sub-Zero dealer. Refer to the illustrations below.
OPTIONAL PANEL GRILLE
An 11" (279) louvered grille is standard on
framed applications. Optional louvered grilles are
available in 1" (25) height increments from 10"
(254) to 15" (381) for all Built-In models except
Models 601R, 601RG, 601F, 648PRO and
648PROG.
You may choose to use Sub-Zero‘s optional
panel grille for some of your framed applications.
The panel grilles can be used with all Built-In
models except Models 601R, 601RG, 601F,
648PRO and 648PROG and are available in 1"
(25) height increments from 10" (254) to 15"
(381).
For each model, the width of the panel grille will
be the same, regardless of the height you have
chosen. To determine the panel grille insert size,
use the width dimension listed for your model
and the height dimension for the grille option
you have chosen. Specifications for the Panel
Grille Option are listed on page 21.
Partial Framed Kit
FRAMPAR
Framed Retrofit Kit
FRAMRET
PANEL
REQUIREMENTS
The weight of
each framed door
panel cannot exceed
50 lbs (23 kg).
FRAMED PANELS
To install framed
panels, see the
detailed procedures
outlined in the
Sub-Zero Built-In
Installation
Instructions.

Sub-Zero 601F Specifications

General

Brand	Sub-Zero
Model	601F
Category	Refrigerator
Language	English