3-7
INSTRUMENT PANEL
78J01-03E
ever, if you use the accelerator to increase
the vehicle’s speed for approximately 60
seconds, cruise control will disengage.
Using Cruise Control on Hills
How well your cruise control works on hills
depends upon your vehicle speed, load,
and the steepness of the hills. While going
up steep hills, you might have to step on
the accelerator pedal to maintain your
vehicle’s speed. While going downhill, you
might have to brake or shift to a lower gear
to limit the vehicle’s speed. Of course,
applying the brakes ends cruise control.
Many drivers find this to be too much trou-
ble and do not use cruise control on steep
hills.
Ending Cruise Control
There are three ways to end cruise control:
• Step lightly on the brake pedal.
• Press the button on the steering
wheel.
• Press the button on the steering
wheel.
Erasing Speed Memory
When the cruise control or the ignition is
turned off, the cruise control set speed
memory is erased.
Headlamps
The exterior lamp control is located on the
turn signal/multifunction lever.
(Exterior Lamp Control):
Turn the control with this symbol on it to
operate the exterior lamps.
The exterior lamp control has the following
positions:
AUTO (Off/Automatic Headlamps):
Turn the control to this position to put the
headlamps in automatic mode. Automatic
mode will turn the exterior lamps on and off
depending upon how much light is avail-
able outside of the vehicle.
(Parking Lamps):
Turn the control to this position to turn on
the parking lamps together with the follow-
ing:
• Sidemarker Lamps
• Taillamps
• License Plate Lamps
• Instrument Panel Lights
(Headlamps):
Turning the control to this position turns on
the headlamps, together with the previ-
ously listed lamps and lights.
Headlamps on Reminder
If you open the driver’s door with the igni-
tion off and the lamps on, you will hear a
warning chime.
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make
it easier for others to see the front of your
vehicle during the day. DRL can be helpful
in many different driving conditions, but
they can be especially helpful in the short
periods after dawn and before sunset.
Fully functional daytime running lamps are
required on all vehicles first sold in Can-
ada.
A light sensor on top of the instrument
panel makes the DRL work, so be sure it is
not covered.
The DRL system’s automatic headlamp
control will make the low-beam headlamps
come on at a reduced brightness when the
following conditions are met:
• The ignition is in RUN.
• The exterior lamps control is in AUTO.
• The engine is running.
When the DRL are on, only the low-beam
headlamps, at a reduced level of bright-
ness, will be on. The headlamps, taillamps,
sidemarker, and other lamps will not be on.
The instrument panel and cluster will also
not be lit.
When it is dark enough outside, the DRL
will turn off and the headlamps and parking
lamps will turn on. The other lamps that
come on with the headlamps will also
come on.
To Next Page
Loading...
Need help?
General
