15
– If the stand is installed
If the dedicated stand (optional) is attached,
reach it duly on the stand table.
2) Vibration-proof rubber
Place the vibration-proof rubbers (four)
under each leveling adjusting bolts. Adjust
the bolts until the caster rises from the floor.
Use the level gauge to check the leveling.
Caster
Fixing nut
Leveling
adjusting bolt
Vibration-proof
rubber
1) Check the voltage supply where the machine will be installed.
2) If the difference in heights of the four bolts is over 10mm, place spacers beneath the lower
level base to make the heights even.
CAUTION
To Next Page
Loading...
Need help?
General
