TaoTronics TT-AP002 User Manual

Installing and Removing the Filter
Note:
1. when the unit is on, the Air Quality indicator will light up to show the current
air quality:
2. To achieve better purif ication, make sure to
keep the purifier 30 centimeters / 11.8 inches
away from walls, furniture and so on and at
least 50 centimeters / 19.7 inches away from
metals / electrical appliances.
3. In sleep mode, press the Sleep Button once to
check the current settings. Press twice to turn
off the sleep mode.
4. In automatic wind mode, the unit will adjust
the fan speed according to the results read by
the dust sensor (dust concentration).
Air Quality Indicator
Green Orange Red
Air Quality Good Moderate Unhealthy
PM2.5
11.8inches
30cm
11.8inches
30cm
Wall Wall
1. Use soft brushes to dust off the f ilter regularly for better purif ication. Don’t wash it with water.
2. Replace the f ilter when the Change Filter Reminder flashes:
ｖ!Unplug the power source.
ｗ Remove the rear grille.
ｘ Take out the old f ilter by pulling the tabs.
ｙ Install a new or the cleaned f ilter and put the rear grille back on.
ｚ Press and hold the ION Button for 3 seconds to reset the unit. The Change Filter Reminder
will turn off.
PUSH
PUSH
PUSH
POWER
Filter
FAN
Low
Mid
High
Turbo
TIMER SLEEP ION
Press 3s, to reset FilterPress 3s, Auto mode
ｖ ｗ
ｘ ｙ
ｚ
02
04
06
08 10 12 14
16 18 20 22
24 26 28 30 32 34
01 03
05
07
09 11 13 15
17 19 21 23
25 27 29 31 33
EN EN

TaoTronics TT-AP002 Specifications

General

Brand	TaoTronics
Model	TT-AP002
Category	Air Cleaner
Language	English