3 DUPLICATOR User Manual
1. Controls
(1) (2) (3)
(5)
(4)
(8)
(6)
(7)
(9) (10)(11)(12)
(1) DOUBLING knob selects the type and amount of doubling e ect on your
voice. The rst two types allow a tight voicing that has less variation from
your original voice, or loose doubling that varies more in pitch and time.
The 3rd type adds an extra voice an octave below your original note. Adjust
the knob within your preferred e ect type to determine the volume of the
second voice.
(2) REVERB knob selects the type and amount of reverb e ect on your voice.
The 3 types of reverb appear in order from the smallest space (Room) to
the largest (Hall). Adjusting the knob within your preferred reverb space
determines how pronounced the e ect will be. Turning the knob fully
counterclockwise turns the reverb o .
(3) CORRECTION knob adjusts the amount of pitch correction. With the knob
at the center 12:00 position, the e ect will provide subtle pitch support
without noticeable or unnatural artifacts. Turn the knob all the way up for a
more aggressive e ect, or fully counterclockwise to turn the e ect o .
(4) BATTERY LED indicates the battery level, with green showing full life,
yellow being partial life, and red to alert that the batteries
should be changed.
(5) TONE button engages a preset combination of adaptive EQ, compression,
de-essing, and noise gate. "Normal" and "Less Bright" settings can be
toggled by holding the Tone button and pressing the footswitch.
(6) ON/OFF LED lights when the e ect is engaged.
(7) FOOTSWITCH bypasses the doubling e ect, but does not a ect the reverb,
correction or Tone status.
(8) USB input accepts a micro USB cable for connection to a computer.
Use the VoiceSupport application to install rmware updates, and for
other features depending on your product. Download VoiceSupport from
tc-helicon.com/products/voicesupport/
(9) ON/OFF switch powers the pedal on and o .
(10) POWER input accepts a 9V power cable (not included).
(11) OUT jack accepts a balanced XLR cable for connection to a mixer or
active speaker.
(12) MIC input jack accepts a balanced XLR cable to connect your microphone.
To Next Page
Loading...
Need help?
General
