GO SOLO
High-Denition Audio/MIDI Interface for Mobile Devices
Connect GO SOLO to a computer, phone or
tablet using the included cables. If using the
provided lightning cable, insert a pair of AA
batteries to power GO SOLO, or connect a 5V power
supply (not included) to power GO SOLO and charge
your iOS device.
Connect microphone, instrument or line-level
source to the input using XLR or ¼" cables.
Plug a pair of headphones into the HEADPHONE
output. Set LEVEL control to minimum to start.
To enable phantom power move the 48 V
power switch to the ON position. The 48 V LED on
the front panel will light blue.
While speaking into the microphone or playing
your instrument, turn up the GAIN wheel. The SIG
LED should light green to indicate a signal present.
If the SIG LED lights red, turn the GAIN wheel down
to avoid clipping.
Connect MIDI devices to the mini 2.5 mm input
and output jacks using the included adapter cables.
Download your favorite TC Helicon app to
begin experimenting with eects.
Quick Start Guide
Getting started
To Next Page
Need help?
General
