26
Note
Do not press PAIR at the back of the wireless
subwoofer during auto pairing.
Manual pairing
1
Make sure the Sound Bar and wireless subwoofer are
properly connected to the power supply.
2
Press and hold PAIR at the back of the wireless subwoofer
The wireless subwoofer is ready to pair.
3
4 LEDs flash.
Pairing is successful. The amber LED remains on solidly.
Note
until
the amber LED on the subwoofer flashes quickly.
If the amber LED at the back of the subwoofer still flashes
after pairing, it means pairing is not successful. Disconnect
the AC power cord from the wireless subwoofer and then
connect again after 3 minutes. Then repeat steps 1 to 3.
Press and hold button on the Sound Bar main unit or
the remote control,
To Next Page
Loading...
Need help?
General
