12
9. Shutdown - With the appliance on, press the to enable this feature.
Then press the or buttons to increase or decrease the timer in 30 minute increments.
After 5 seconds of inactivity, the Timer symbol will light up and this feature will be active.
10. Lock - The lock function prevents from someone accidentally changing the settings. To lock
the panel, simultaneously press and hold down the and buttons for 3 seconds. The
Lock symbol will light up when this feature is enabled. To unlock the control panel, press and
hold the and buttons for 3 seconds. The Lock symbol light will turn o.
11. Filter - When the filter needs to be cleaned, the Filter symbol will light up. This will light
up after every 250 hours of use and is used a reminder (not an actual indicator that the filter
is dirty). Remove the filter from the back of the unit by using your thumbs to press down on
the filter tabs directly above the filter. Clean the filter with warm, soapy water. Dry thoroughly
before replacing the filter. Once the filter is completely dry, place the filter back in the unit
and hold the for a few seconds to reset the filter indicator.
12. Tank Full - When the water bucket is full, the Tank Full symbol will light up and the
compressor will turn o. The fan may continue to run for a few more minutes. Remove the
bucket with both hands and empty. Do not place the bucket on the floor when it is full
because the bottom is not flat.
Cleaning the water tank - It is recommended to clean the bucket the with a mild detergent every
week to prevent the growth of mold, mildew, and bacteria. Once clean, completely dry the bucket
and, using two hands, place it back inside the appliance.
For Model(s) with PUMP
1. PUMP - Enable this function for use with a drain hose. Connect the pump drain tube and
adapter to the back of the unit. Press the PUMP button and verify the light next to the Pump
symbol turns on.
Note: Water will still drain into the bucket but the pump will engage when the bucket is almost full.
For Model(s) with UVC
Press and hold for 3 second until the UV indicator turns on. To turn the UV function o, press
and hold the mode button for another 3 seconds until the indicator turns o.
Should any UV light be exposed, stop use immediately and contact customer service.
Automatic Defrost - When frost builds up on the evaporator coils, the compressor will stop and
the fan will continue to run until the frost disappears. When the coils are completely defrosted, the
compressor will automatically restart and dehumidify will resume. If the frost does not completely
melt on its own, unplug the appliance overnight. Be sure to confirm the filter is clean before
running again.
To Next Page
Loading...
Need help?
General
