5
5. Network indicator
•Blinking blue: the device is registered to the network.
•Solid blue: the device is connected to the network.
•Solid red: micro SIM card is not available or the device is
not registered to the network.
6. External antenna port
Install an external antenna to improve signal reception.
7. WPS button
Press the button for 3 seconds to enable the WPS function.
The WPS function will be automatically disabled if a WPS
connection is not established within 2 minutes.
8. Power button
•Press for 3 seconds to power off your device.
•Press for 1 second to power on your device.
9. Micro SIM card slot
Insert a micro SIM card in the slot.
10. Reset button
Use a paperclip to press the button for 3 seconds to reset
the device.
11. LAN port
Used to connect to wired devices such as computers or
switches.
12. LAN/WAN port
Used to connect to an internet source or wired devices such
as computers or switches.
13. Power connector
Used to connect to the power adapter.
When the CPE downloads and installs software updates, you will see the indicators
flash on and off in a sequence. Do not power off your CPE during this process as it
may cause device malfunction.
To Next Page
Loading...
Need help?
General
