Technics SA-GX370 User Manual

i
How
to
use
the
antenna
plug
(included)
(For
areas
except
United
Kingdom
and
Europe)
Two
types
of
wire
are
most
commonly
used
for
connection
from
the
antenna:
300-ohms
parallel
feeder
wire
or
75-ohms
coaxial
cable.
For
best
resistance
to
outside
interference,
the
use
of
75-
ohms
coaxial
cable
is
suggested.
To connect a 75-ohms coaxial cable
@ Remove a piece of the outer vinyl insulator.
| > e-
L
20 mm (25/32”) 10 mm (3/8”)
@
Remove
the
cover
while
pulling
the
tabs.
If
the
tabs
are
pulled
too
hard,
the
casing
may
be
damag-
Plastic bar
Clamp the cable
conductor, and wind it
on so that it doesn’t
contact anything else.
with pliers.
@® Attach the cover.
300-ohms
feeder wire
(not included)
Loosen the screw to connect the
feeder wire and tighten it to secure
the connection.
AM loop antenna (included)
This antenna is normally sufficient for reception of MW/LW broad-
casts.
AM loop antenna
(included)
AM LOOP ANT
Install the AM antenna holder (included) at the rear panel of this
unit and then attach the AM loop antenna to the AM antenna
holder (facing in the direction of best reception).
Insert the tab into
a the hole and then
ay
push
the
holder
downward.
AM antenna holder
(included)
When mounting the antenna to a column, a wall
or rack
Mount it vertically.
AM antenna holder
(included)
Screw (included)
Pay attention to the following points when mounting the
antenna.
¢ Do not mount it horizontally (doing so will impair reception).
© Do not mount it close to power cords, speaker wires or metal
surfaces (doing so will result in noise).
© Do not mount it close to a tape deck. When the tape deck is be-
ing used, chirping or beeping sounds may result.
I]

Technics SA-GX370 Specifications

General

Brand	Technics
Model	SA-GX370
Category	Stereo Receiver
Language	English