Technics SL-D2 Service Manual

SL-D2/K
m
DISASSEMBLY
PROCEDURE
How to remove the bottom plate (Fig. 5)
1) Remove the head shell and turntable.
2) Secure the tone arm with the arm clamper.
3)
Turn
over
the
set
taking
care
not
to
damage
the
dust
cover.
4) Remove the 7 bottom plate setscrews @.
Note)
Be
careful
not
to
lose
the
boss
cap
attached
to
the insulator on the cabinet side.
How to remove the radiating fin (Fig. 6)
1) Remove the bottom board as explained above.
2) Remove the 4 setscrews © of the radiating fin.
3) Remove the 2 setscrews © of the top radiating fin.
| : ; Tonearm
Removal
of
drive
P.C.B.
and
automatic
mechanism
Ses:
i
Ro
Plate
’
:
7
ae
'§
SE
ss’y
ass y (Fig. 6) Pl SZ is, | Automatic
1)
Remove
the
bottom
board.
=
Ne
Ww
ee
ec
at
2)
Remove
the
speed
change
knob.
|
8
om
Ws
_
\
3) Remove the 4 setscrews ® of the automatic mechanism
ass'y.
4)
Remove
the
4
setscrews
@
of
the
drive
P.C.B..
_
|
—_
A
|
es
Plate
5)
Pull
out
the
boards
in
the
direction
of
the
arrow
@
as
Fig.
6
illustrated.
Note) 1. Pull the start plate in the direction of the
arrow @ because it may otherwise come in
touch with the tone arm fixing plate ass’y.
2. Since the neon cover is fixed being in contact
with the drive P.C.B. take care not to lose the
:
Soldered
neon
cover
when
removing
the
base
palte.
Soldered
Removal of stater coil (Fig. 7)
1) Remove the 3 setscrews of the stator cover of the
removed drive P.C.B..
2) Disconnect the 18 soldered parts of the stater coil.
3) Remove the 3 setscrews @ of the stator coil and P.C.B.
board.
Then, the stater coil can be removed. When installing,
position the stater coil as shown by the arrow @.
Soldered
Precautions for assembly
Note)
When
assembling
the
mechanical
and
drive
P.C.B.,
follow
the
procedure
below.
(Fig.
6)
1) Temporarily secure the 3 setscrews of the stator coil.
2)
Secure
the
automatic
mechanism
ass’y
with
4
setscrews.
(Pull
the
actuating
plate
ass’y
in
the
direction
of
the
arrow
2
or
otherwise
it
may
touch
the
tone
arm
fixing
plate
ass’y.)
3)
There
is
some
clearance
between
the
drive
P.C.B.
and
automatic
mechanism
ass’y
in
the
direction
of
the
arrow
3.
Find
a
position
where
the
pitch
control
knob
doesn’t
touch
the
cabinet,
and
then
install
the
drive
base
plate
with 4 setscrews.

Technics SL-D2 Specifications

General

Brand	Technics
Model	SL-D2
Category	Turntable
Language	English