Technics SL-PG340 User Manual

Precautions
Environment
Maintenance
Service
3
Clean the cabinet, panel and controls with a soft cloth lightly moist 
ened with mild detergent solution.
1. Damage Requiring Service - The unit should be serviced by
qualified service personnel when.
(a) The AC power supply cord or the plug has been damaged; or
(b) Objects have fallen or liquid has been spilled into the unit; or
(c) The unit has been exposed to rain; or
(d) The unit does not appear to operate normally or exhibits a
marked change in performance; or
(e) The unit has been dropped, or the enclosure damaged.
2. Servicing - The user should not attempt to service the unit
beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
•THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORM 
ANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPO 
SURE.
DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.
REFER SERVICING TO QUALIFIED PERSONNEL.
Do not use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.
7. Wall or Ceiling Mounting - The unit should not be mounted to a
wall or ceiling, unless specified in this operating instructions.
5. Surface -- Place the unit on a flat, level surface.
6. Carts and Stands -- The unit should be used only with a cart or
stand that is recommended by the manufacturer. The unit and
cart combination should be moved with care.
Quick stops, excessive force, and uneven sur 
faces may cause the unit and cart combination to
overturn.
3. Power Cord Protection - AC power supply cords should be
routed so that they are not likely to be walked on or pinched by
items placed upon or against them. Never take hold of the plug or
cord if your hand is wet, and always grasp the plug body when
connecting or disconnecting it.
4. Nonuse Periods -- When the unit is not used, turn the power off.
When left unused for a long period of time, the unit should be
unplugged from the household AC outlet.
Radio Interference Regulations of the Canadian Department of
Communications.
If moisture forms inside this unit, it may not operate properly. To
correct this problem, turn on the power and wait about one hour
for the moisture to evaporate.
3. Heat - The unit should be situated away from heat sources such
as radiators and the like. It also should not be placed in tem 
peratures less than 5°C (41 °F) or greater than 35°C (95 C F).
Before using this unit please read these operating instructions
carefully. Take special care to follow the warnings indicated on the
unit itself as well as the safety suggestions listed below.
Afterwards keep them handy for future reference,
Safety ---------------------------
CAUTION:
•This equipment has been tested and found to comply with the
limits for a Class B computing device in accordance with the
specifications set forth in Subpart J of Part 15 of the FCC Rules.
If this equipment does cause interference to radio or television
reception which can be determined by turning the equipment on
and off, use the equipment in another location and/or utilize an
electrical outlet different from that used by the receiver.
•This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus set out in the
1. Power Source - The unit should be connected to power supply
only of the type described in the operating instructions or as
marked on the unit.
2. Polarization - If the unit is equipped with a polarized AC power
plug (a plug having one blade wider than the other), that plug will
fit into the AC outlet only one way. This is a safety feature. If you
are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact your electrician to
replace your obsolete outlet. Do not defeat the safety purpose of
the polarized plug.
Installation ---------------------
1. Ventilation -- The unit should be situated so that its location or
position does not interfere with its proper ventilation. Allow 10 cm
(4") clearance from the rear of the unit
2. Foreign Material -■ Care should be taken so that objects do not
fall into and liquids are not spilled into the unit. Do not subject this
unit to excessive smoke, dust, mechanical vibration, or shock
3. Magnetism -- The unit should be situated away from equipment
or devices that generate strong magnetism.
4. Stacking - Do not place heavy objects, other than system com 
ponents, on top of the unit
1. Water and Moisture - Do not use this unit near water — for
example, near a bathtub, washbowl, swimming pool, or the like.
Damp basements should also be avoided.
2. Condensation - Moisture may form on the lens in the following
cases..
• immediately after a heater has been turned on.
• in a steamy or very humid room.
• when the unit is suddenly moved from a cold environment to a
warm one.
Placement ----------------------------------------

Technics SL-PG340 Specifications

General

Brand	Technics
Model	SL-PG340
Category	CD Player
Language	English