Technics ST-G3 Service Manual

@ CONTENTS
Page Page
SAFETY PRECAUTION. .........-. 2-02 ee eee eee 2 TERMINAL GUIDE OF TRANSISTORS,
LOCATION OF CONTROLS... .. 2... 0.0. e ee eevee eee 3 IC’S AND DIODES... . 1... .. 2. pe ee ee eee 11
HOW TO PRESET RADIO BROADCAST FREQUENCIES... 4,5 FUNCTION OF TERMINAL (1C901 : u«PD1714G511) ...... 12
DISASSEMBLY INSTRUCTIONS ............2..-0285 6 BLOCK DIAGRAM. .........-2-.2.20 5+ 22 eeeee 13, 14
MEASUREMENTS AND ADJUSTMENTS ............ 7,8 SCHEMATIC DIAGRAM ..............225285 15 ~ 18
CIRCUIT BOARD AND WIRING RESISTORS, CAPACITORS &
CONNECTION DIAGRAM ...........02.080005 9,10 REPLACEMENT PARTS LIST..............-.- 19, 20
DESCRIPTION OF LCD PANEL. ...........-22005- 11 EXPLODED VIEW... 2... 2... . ee ee eee ee es 21, 22
m SAFETY PRECAUTION
arWN
WON @
. Before servicing, unplug the power cord to prevent an electric shock.
. When replacing parts, use only manufacturer's recommended components for safety.
. Check the condition of the power cord. Replace if wear or damage is evident.
. After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
. Before returning the serviced equipment to the customer, be sure to make the following insulation resistance test to
prevent the customer from being exposed to a shock hazard.
INSULATION RESISTANCE TEST
. Unplug the power cord and short the two prongs of the plug with a jumper wire.
. Turn on the power switch.
. Measure the resistance value with ohmmeter between the jumpered AC plug and each exposed metal cabinet part, such as
screwheads antenna, control shafts, handle brackets, etc. Equipment with antenna terminals should read between 3MQ
and 5.2MQ to all exposed parts. (Fig. A) Equipment without antenna terminals should read approximately infinity to
all exposed parts. (Fig. B)
Note: Some exposed parts may be isolated from the chassis by design. These will read infinity.
4,
Antenna
terminal
Exposed Exposed
metal metal
part part
Ohmmeter Ohmmeter
(Fig. A) (Fig. B)
Resistance = 3M2—5.2MQ Resistance = Approx oo
If the measurement is outside the specified limits, there is a possibility of a shock hazard. The equipment should be
repaired and rechecked before it is returned to the customer.

Technics ST-G3 Specifications

General

Brand	Technics
Model	ST-G3
Category	Tuner
Language	English