WT549 Manual
EN10
carries out the synchronization procedure with the
DCF signal to correct any deviations to the exact
time. If this synchronization attempt is unsuccessful
(the radio mast icon disappears from the display),
the system will automatically attempt another
synchronization at the next full hour. This procedure
is repeated automatically up to total 5 times.
To start manual DCF signal reception, press and
hold down the “+” and “-” buttons for two seconds. If no
signals received within 7 minutes, then the DCF signal
search stops (the radio mast icon disappears) and
start again at the next full one hour.
Please note:
A flashing radio mast icon indicates that the DCF
signal reception has started
A continuously displayed radio mast icon indicates
that the DCF signal was received successfully
We recommend a minimum distance of 2.5 meters
to all sources of interference, such as televisions
or computer monitors
To Next Page
Loading...
Need help?
General
