Appendix A: Specifications
.-,-
Table A-7: Typical characteristics -triggering system
requencies
above
80 kHz. Attenuates signals below
2 The waveform interval (WI) is the time between the samples in the waveform record. Also see the footnote for the
3
characteristics Sample Rate Rang6 and Equivalent Time or Interpolated Waveform Rates in Table A+ on page A-8.
The minimum sensitivity for obtaining a stable trigger. A stable trigger results in a uniform, regular display triggered on
the selected slope. The trigger point must not switch between opposite slopes on the waveform, and the display must not
“roll” across the screen on successive acquisitions. The TRIG’D LED stays constantly lighted when the SEC/D/DIV setting
is
2
ms or faster but may flesh when the SEClOtV setting is 10 ms or slower.
4
See the characteristic Sensitivify, Edge-Type Trigger, DC Coupledin Table A-3, which begins on page A-3.
Ta’ahk A-8; Typical characteristics-probe compensator output
Name
Output Voltage and Frequency,
Probe Compensator
Description
Characteristic
Voltage
Frequency
5.0 V (low-high) into a 1 MQ load
1 kHz
TDS 340, TDS 360 g: TDS 380 User Manllal
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
