Tips
Do not hold down the MESH button for 8 seconds
if unnecessary.
Button
MESH
RESET
MESH button.
− As a networking button: Press this button on this
device for about 1 to 3 seconds. The LED indicator
blinks green fast, which indicates the device is
searching for another device to form a network.
Within 2 minutes, press the MESH button of another
device for 1 to 3 seconds to negotiate with this
device.
− As a de-networking button: Press this button for
about 8 seconds and release it when the LED
indicator blinks red fast. The node is restored to
factory settings, and also removed from the
network and no longer automatically joins in again.
Reset button.
When the device completes startup, hold down this
button using a needle-like item (such as a pin) for
about 8 seconds, and then release it when the LED
indicator blinks red fast. The device is reset
successfully.
Description
To Next Page
Loading...
Need help?
General
