English
01
I Connect the node
1. Power off your modem.
2. Use the included Ethernet cable to connect the WAN port of the device to the
LAN port of your modem or the Ethernet jack.
3. Power on your modem.
4. Power on the node, and wait until the LED indicator blinks green.
*If you purchased a kit, choose one device from the kit to connect to the internet
as the primary node in the network.
(MX12 used for example. Wiring of other models is
similar regardless of their appearance.)
• Mesh device x 3 (3-pack)/2 (2-pack)/1 (1-pack) • Ethernet cable x 1
• Power adapters x 3 (3-pack)/2 (2-pack)/1 (1-pack) • Quick installation guide x 1
Button/
Interface
Description
MESH
RESET
RST
LAN3/IPTV
LAN2
1 2 3
WAN/LAN
WAN/LAN1
POWER
PWR
Tips
If you do not use a modem for internet access, skip steps 1 and 3.
The buttons and interfaces may vary with models.
Internet
Gigabit
port
or
Modem (such as
optical modem)
Ethernet jack
Ethernet cable
Power outlet
Package contents
Button/Interface
Please read this guide before you start with the quick setup upon the first use. MX12 is
used for illustration here unless otherwise specified. The actual product prevails.
For initial internet connection with the Mesh device used as a router, see I to II if you
bought 1-pack and see I to III if you bought 2-pack or 3-pack.
For extending the WiFi network of exisiting Tenda devices that support the Mesh
function, see III.
MESH button.
- Networking: Press this button for about 1 to 3 seconds. The
LED indicator blinks green fast. Within 2 minutes, press the MESH
button of another device for 1 to 3 seconds to negotiate with this device.
- De-networking (DO NOT operate unless necessary): Press this button
for about 8 seconds and release it when the LED indicator blinks red fast.
The node is reset and removed from the network and no longer
automatically joins in again.
Reset button.
When the device completes startup, hold down this button using a
needle-like item (such as a pin) for about 8 seconds, and release it when
the LED indicator blinks red fast. When the LED indicator lights solid
green and then blinks slowly, the device is reset successfully.
LAN/IPTV multiplexing port, LAN port by default.
LAN port.
WAN/LAN multiplexing port, WAN port by default.
WAN/LAN auto-adaptive port.
Power jack.
To Next Page
Loading...
Need help?
General
