www.tissot.ch
137_EN / 06.12
4/4
Synchronization
This operation can only be performed visually, and it enables you to synchro-
nize the hands to the vibration signals. To do this:
– Press the button (3) for more than 2 seconds.
– Sense a first vibration.
– By holding your finger down on the button (3), sense a second vibration
after 10 seconds.
– Position the hour hand at 12 o'clock by placing a finger on the crystal (5) at
9 or 10 o'clock to move the hour hand anticlockwise or at 2 or 3 o'clock to
move the same hand in a clockwise direction.
– Position the minute hand at 12 o'clock by placing a finger on the crystal (5)
at 7 or 8 o'clock to move the minute hand anticlockwise or at 4 or 5 o'clock
to move the same hand in a clockwise direction.
Please note: After 10 seconds when the Silen-T is not in use, the hands
once again show the correct time and a single press on the button (3) acti-
vates the touch-sensitive crystal (5), regardless of the function previously
used. After 8 minutes of operation without the button (3) being pulled out, the
Silen-T moves into " standby " mode (power-saving mode).
Care and maintenance
We would advise you to clean your watch regularly (except for the leather
strap) using a soft cloth and warm soapy water. After immersion in salty
water, rinse it in fresh water and leave it to dry completely.
Ensure that you do not leave it to dry in places subject to great variations in
temperature and humidity, in direct sunlight or near strong magnetic fields.
TISSO
T
®
quartz watches benefit from the incomparable precision of quartz
movements. Their power reserve usually enables them to operate for more
than 2 years in continuous use. If you ever plan not to be wearing your watch
for a period of several weeks, or even several months, we would advise you
to pull out the button before putting your watch away (3). This reduces the
level of electrical power drawn off by the motor, thereby substantially exten-
ding the service life of the batteries.
Replacing the batteries
When your batteries are approaching the end of their useful service life,
this is signalled to you with two vibrations each time you handle the watch.
The first of these is short, and the second is longer (E.O.L. function).
The 2 batteries need to be replaced simultaneously without delay by either
a retailer or an official
TISSO
T
®
agent.
Battery type: button-type lithium-manganese dioxide primary battery cell,
Renata 350, 1,55 V, Ø 11,60 mm, h. 3.6 mm.
Collection and treatment of end of life quartz watches*
This symbol indicates that this product should not be disposed with
household waste. It has to be returned to a local authorized col-
lection system. By following this procedure you will contribute to
the protection of the environment and human health. The recycling of the
materials will help to conserve natural resources.
* valid in the EU member states and in any countries with corresponding
legislation.
To Previous Page
Loading...
Need help?
General