TomTom Go 720 User Manual

EN
Remote control
4
Remote
control
Important: This TomTom product is Bluetooth
enabled. Please note that in certain environments
such as hospitals or airplanes, you are required to
switch off Bluetooth, on all electronic devices.
Inserting the batteries
1. Hold the sides of the remote control and press the
latch on the back of the device.
The keypad lifts out from the back of the device,
as shown in the diagram. Take care not to drop
the keypad.
2. Place the batteries in the remote control. Make
sure you put the batteries in the correct way
round, as shown on the remote control.
3. Replace the battery cover and press any button to
switch on your remote control.
Your remote control starts searching for your
TomTom GO.
Note: If you do not use your remote control for 20
seconds, it goes into power saving mode.
If you do not use your remote control for one hour,
the remote control switches off completely.
Press any button to switch your remote control on.
Remote-Control-Accessory.book Page 4 Friday, November 9, 2007 3:56 PM

TomTom Go 720 Specifications

Display

display type	full TFT color LCD touchscreen
display size	4.3 inches
display colors	64k colors
display resolution	480 x 272 pixels

Power and Battery

battery type	Lithium-polymer
battery life	5 hours
charging connection	USB

Processor and Memory

processor	400 MHz
internal memory	2 GB
external memory support	SD slot

Operating Environment

operating temperature	14˚ F to 131˚ F

Weight and Dimensions

dimensions	4.6 x 3.3 x 0.9 inches
weight	7.8 ounces