1. Remove all parts and accessories from parts box and check against the enclosed list.
2. Turn the table upside down, taking care not to scratch the top or bend the Corner Cap
(assemble on carpet).
3. Remove the nuts and washers from each leg and insert the leg into the two diagonal
holes in the bottom of the game.
4. Assemble the nuts and washers to the leg bolts and finger tighten. Make sure each leg
is pulled squarely into the comer of the cabinet on all four sides, before tightening
with a wrench. Be careful not to over-tighten the nuts. Make sure the Leg Levelers are
screwed in all the way.
5. Have two people set the table upright. Wipe it off with a damp cloth.
6. Thread the appropriate rods through the corresponding bearing hole (be careful,
there are four 3-holed rods and the two shortest of these four rods are the goalie
rods). Thread the rod through one side of the cabinet and wipe a thin coating of
silicone on the rod using a cloth or paper towel. Thread one black rubber bumper
onto the rod (make sure that the side of the bumper with the holes always faces the
cabinet wall).
7. Thread the appropriate number of men onto each rod (smiling face of black men
facing yellow goal and smiling face of yellow men facing black goal), followed by
another rubber bumper on the far end. Slide the end of the rod into the bearing hole
in the opposite cabinet wall.
To Next Page
Loading...
Need help?
General