CONNECTIONS
The box is connected with 3 cables
- 12V DC - Power supply - 230Volt adapter
- HDMI cable that connects to your TV into an available HDMI input
- WAN - Network cable that connects to your broadband connection / router / Internet connection
Turn on the TV
Use your remote control for your TV to switch to the entrance where you installed the HDMI cable. This is usually
done via AV / Source / Input button on your TV remote.
- Remember that there may be multiple HDMI inputs on your TV. Please take note of the number of the input
you are using (HDMI1 - HDMI2 etc.)
LIGHTS ON THE FRONT OF THE RECEIVER:
FIG. Correct when in use (2 green lights)
Turn on the BOXTV receiver with the small switch is on the right side of the receiver - here lights should react as
follows:
On the TV screen: LOADING PLEASE WAIT while the three lights on the front panel act as follows:
o RED (flashing)
o GREEN
o RED
Then, the upper light flashes GREEN / RED for approx. 20 seconds.
To Next Page
Need help?
General
