1
All Rights Reserved
Printed in the USA
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Finish Grader Kit
Sand Pro
)
3040 & 5040
Model No. 08754–Serial No. 260000001 and Up
Form No. 3354–263 Rev. A
Installation Instructions
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
106-5517
1. Warning—do not touch the hot surface.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description Qty. Use
Finish Grader Assembly 1 Mount to the Sand Pro lift arm adapter
Parts Catalog 1
Installation Instructions 1
Installation
Mount the Finish Grader to the Traction
Unit
1. Remove any attachment from the rear of the machine.
2. Back the traction unit into position in front of the
attachment adapter. Lower the traction unit adapter.
Note: Make sure the locking lever (Fig. 1) is pivoted to
the left (unlocked position) as viewed from the rear of the
machine.
3. Raise the traction unit adapter into the attachment
adapter.
4. Pivot the locking lever to the right to lock the adapters
together.
1
2
Rear of machine
Figure 1
1. Attachment adapter 2. Locking lever
To Next Page
Need help?
General
