Toro Precision User Manual

Step 3– Install the Sensor and Adjust Your Timer
1. Locate and remove the sensor battery compartment cover.
2.InsertthreeAAalkalinebatteriesasshown.Installbattery
compartment cover (Fig. 4).
Note: The LED signal indicator on top of the sensor will be on for
several minutes to assist in sensor placement.
3. With the sensor at the selected site, verify signal strength,
indicted by the sensor LED color: Green - Excellent,
Yellow - Acceptable, Red (blinking) - Relocate the sensor.
4. Holding the sensor parallel to the ground, push the probes
and stakes straight down through the lawn into the soil until
the sensor is pressed at against the ground (Fig. 5).
5. At the receiver, press the Bypass
button once. The green
LED will begin blinking and the receiver will display “CA” as it
begins the automatic 24–48-hour calibration operation (Fig. 6).
6. Adjust your sprinkler control timer:
 •Setthewateringdayscheduletowatereverydayoftheweek
(except watering-restricted days).
 •Settheruntimedurationusedduringthesummermonths.
 •Runamanualwateringoperationtowaterallzones.
This completes basic installation and setup. For complete
information, be sure to
download your Precision Soil Sensor
User’s Guide at:
www.toro.com.
4
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC Rules. For complete FCC compli-
ance rules, see Precision Soil Sensor User’s
Guide, form number 373-0604.
LED Signal
Indicator
Stakes
Probes
Fig. 5
Fig. 4
Fig. 6

Toro Precision Specifications

General

Brand	Toro
Model	Precision
Category	Accessories
Language	English