V-ENGINE SERVICE MANUAL
Table of Contents – Page 1 of 3
ABOUT THIS MANUAL
SAFETY INFORMATION
SPECIFICATIONS
ENGINE SPECIFICATIONS
ENGINE FASTENER TORQUE REQUIREMENTS
CARBURETOR SPECIFICATIONS
SPECIAL TOOL REQUIREMENTS
SPECIAL TOOL REQUIREMENTS - REQUIRED SERVICE SUPPLIES
TORO 2-CYCLE V ENGINE TOOL REQUIREMENTS
TROUBLESHOOTING
ENGINE WILL NOT START WHEN "COLD"
ENGINE WILL START WHEN "COLD", BUT NOT WHEN "HOT"
ENGINE WILL NOT PRODUCE SPARK
ENGINE FLOODED WITH FUEL
ENGINE HAS LOW COMPRESSION
ENGINE LACKS POWER
ENGINE SURGES
ENGINE BACKFIRES
ENGINE OVERHEATS
ENGINE VIBRATES EXCESSIVELY
ENGINE CRANKSHAFT WILL NOT TURN
ENGINE PRODUCES MECHANICAL KNOCKING SOUND
ENGINE PRE-IGNITES
ENGINE SMOKES EXCESSIVELY
ENGINE STALLS
SPARK PLUG FOULED
MAINTENANCE
RECOMMENDED MAINTENANCE SCHEDULE
AIR FILTER - CLEANING
SPARK PLUG
SPARK PLUG GAP
SPARK PLUG TORQUE
EXHAUST SYSTEM - CLEANING
REASSEMBLING
PRIMER START CARBURETOR
TROUBLESHOOTING - ENGINE STARTS HARD
ENGINE RUNS RICH
ENGINE RUNS LEAN
FUEL LEAKS FROM CARBURETOR
INTRODUCTION - IDENTIFICATION
To Next Page
Need help?
General
