22
Operating Manual Cruise 2.0 R / 4.0 R
4.Nowconnectthehighcurrentplugofthecablesettothehighcurrentplugofthemotor.
5. Switch the master switch of the cable set to the on position.
Theadaptercableset/PowerbatteryisequippedwithanANL125Afuse.Incaseofa
short circuit, the fuse cuts the circuit and prevents any further damage.
After installing the batteries please use the remote throttle control to transfer information
about the battery bank to the motor’s on-board computer (Section 9.2, Setup mode). Only
in this way is it possible to determine the loading status and ranges.
9. Operation
9.1 Transom bracket
The tilt mechanism allows both tilting and trimming the motor.
You can tilt the motor to remove it from the water (e.g. when it is not in use or when you
land the boat in shallow water).
Trimming allows you to set the motor perfectly to the water surface. For this there are 4
possible trimming positions.
See Section 8.1 (Fitting the drive onto the boat) to find out how to tilt and trim the motor.
The kick lever in the “Tilt/Auto kick-up” position enables the motor to be kicked up if it
touches the bottom. In this position it is not possible to reverse at full speed.
Automatic kick-up is switched off in the “Lock” position. This enables reversing at full
speed.
To Next Page
Loading...
Need help?
General
