18
SETTING UP YOUR TV
English
DTV Manual Tuning
NOTE: This feature varies depending on the Ant/Cable In
setting.
This feature is available for service engineers or can be used for
direct channel entry if the multiplex channel is known.
a Select DTV Manual Tuning from the SETUP menu
and press OK.
b Enter the multiplex number using the number
buttons or use
C or c to adjust the number up or
down.
c Highlight Start Scan and press OK. The television will
automatically search for that multiplex.
When the multiplex is found, any channels that are
not currently in the channel list will be added and the
channel information at the top of the screen will be
updated.
d Repeat as necessary. Press EXIT to finish.
When Ant/Cable In is set to Cable, DTV Manual Tuning
items are as follows:
Frequency – input a specific frequency to be scanned
Modulation – choose from one of five QAM modulation
options
Symbol Rate – input a specific baud rate (KS/s) to be used for
the manual scan
Manual Tuning
To Next Page
Loading...
Need help?
General
