32
2.SENDING A FAX
2
4. SETTING THE TRANSMISSION CONDITIONS
Variety of Optional Functions
Originals can be sent using different transmission conditions (resolution, image quality mode, exposure,
transmission mode, original size, ECM, quality TX, Line, SUB/SEP/SID, PWD, subject and body). Settings
for the subject and body are available only when using the Internet Fax function.
If you change the transmission conditions, the new settings are valid for one transmission only. They are
returned to the default settings after transmission. The following describes the settings of each item.
- Resolution:
Set the resolution before you scan the original to be sent.
STANDARD: Original with regular size text
FINE: Original with small size text and fine illustrations
U-FINE: Original with ultra-fine illustrations
If the remote Fax cannot receive originals with the same resolution, the resolution of the sent original is
automatically converted and sent. The finer the resolution is, the longer it takes to send an original.
- Image Quality Mode:
Set the image quality mode before you scan the original to be sent.
TEXT, TEXT/PHOTO, PHOTO
* Transmission time may be longer than usual when the TEXT/PHOTO mode or PHOTO mode is selected.
- Exposure:
Set the image density according to the contrast of the original to be sent.
AUTO, MANUAL (11 variations)
* In the automatic exposure mode, the digital copier automatically judges the contrast of the original, and
selects the ideal contrast.
* In the manual exposure mode, you can adjust the contrast manually with 11 variations.
- Transmission Type:
Set the transmission type.
MEMORY TX: Send the original after it is scanned into memory.
DIRECT TX: Send the original directly as it is being scanned.
- Original Size:
Set the scan size of the original to be sent.
AUTO: The size of the original is automatically determined before it is scanned.
SPECIFIED SIZE: The original is scanned at the preset size regardless of its actual size.
Use this mode when you are using non-standard size paper or you want to limit the area of the original
to be sent.
DIFFERENT WIDTH: Set this function to send the originals with different width at a time using Reversing
Automatic Document Feeder. "Sending Different Width Originals" Page 36
* When originals are placed in the reversing automatic document feeder, they are scanned in the AUTO
mode. You can specify the size only when the original is placed on the original glass.
- ECM:
ECM (Error Correction Mode) is an internationally standardized communication mode that automatically
corrects errors that occur during Fax transmissions. Even when the transmitted data has been affected
by noise during communication, this mode allows good communication without image distortion by
automatically resending the part that has been affected.
ON, OFF
* Both the transmitter and the receiver must have the ECM function to make ECM communication
available. When affected by noise during communication, communication time takes longer than usual.
To Next Page
Loading...
Need help?
General