FLUSH
A small volume of water is
used to flush the toilet bowl clean.
・Use this if the toilet paper is not flushed away.
Full flush
Half flush
AUTO WAND
CLEANING
The wand is
cleaned with clean
sterilized water.
■Operation is also possible using
the buttons on the control panel.
■You can flush the toilet bowl
using the manual lever (for
toilet bowl flushing in power
failure) during power failure.
Hand lever
■
MASSAGE
◆“Washlet”is a registered trademark of TOTO.
Standard Use
Essential Points of Use!
Press a button on the remote control; a beep sounds when the top unit receives the signal.
WASH
DRY
STOP
Stops rear washing
and other operating
functions.
Washing the rear.
For washing rear using mild water pressure.
Serves as a bidet for ladies.
OSCILLATING
If you press the button again
during use, the wand moves
back and forth so that you can
wash your rear thoroughly.
Dries wet parts using
warm air.
Low Battery
warning mark
POWER
DEODORIZE
Increases air suction
power for powerful
deodorization.
Setting confirmation
The current settings
can be checked
from the LED.
●
The function that can be used when you press the “REAR”,
“SOFT REAR” or “BIDET” button during use.
The wand returns to the standard
position (3rd step) each time
the wash button (“REAR”, “SOFT
REAR” or “BIDET”) is pressed.
If you press the water pressure
adjustment button, the lamp lights for
about 10 seconds at the preset position.
If you press a wash button (Rear, Soft
or Bidet), the lamp lights for about 10
seconds at the preset position.
■
WATER PRESSURE ADJUSTMENT
(5 steps.)
■
WASH POSITION
ADJUSTMENT
(5 steps.)
Washes with the water
pressure pulsating
between soft and strong.
2015. 3. 2
Product functions and shape may differ depending on the model.
To Next Page
Need help?
General