385
5-4. Other interior features
5
Interior features
4RUNNER (U)
■
Programming HomeLink
®
Steps through must be performed within 60 seconds, other-
wise the indicator light will stop flashing and programming will not
be able to be completed.
Press and release the HomeLink
®
button you want to program
and check that the HomeLink
®
indicator light flashes orange.
Point the remote control
transmitter for the device 1 to
3 in. (25 to 75 mm) from the
HomeLink
®
buttons.
Keep the HomeLink
®
indicator
light in view while programming.
Program a device.
Programming a device other than an entry gate (for U.S.A. own-
ers)
Press and hold the HomeLink
®
button you want to program and the
remote control transmitter button simultaneously. When the
HomeLink
®
indicator light changes from slowly flashing orange to
rapidly flashing green (rolling code) or continuously lit green (fixed
code), release both buttons.
Programming an entry gate (for U.S.A. owners)/Programming a
device in the Canadian market
With one hand, press and hold the HomeLink
®
button you want to
program. With your other hand, press and release the remote con-
trol transmitter button every 2 seconds and repeat this cycle until
the HomeLink
®
indicator light starts to flash rapidly. Then, release
the buttons.
1 3
1
2
3
To Next Page
Loading...
Need help?
General
