Quick Installation Guide
AV600 Powerline Wi-Fi Extender
Applicable to TL-WPA4220, TL-WPA4226, and their multiple-pack kits
* TL-WPA4220 KIT (European version) is used for demonstration in this QIG.
Image may differ from actual product.
7106506157 REV4.0.6
Plug and Play
Set Up a New Wireless Network
Extender
(TL-WPA4220)
Wait until the Powerline
LED turns on.
3
More:
To add additional powerline
adapters or extenders with the default
settings, simply plug them into the wall
sockets on the same electrical circuit.
4
Enjoy!
Use the default wireless network name
(SSID) and password on the provided
Wi-Fi Info Card to access the Internet.
Adapter
(TL-PA4010)
Clone Your Router’s Wi-Fi Settings to the Extender (Recommended)
If your router supports WPS, you can continue with the steps below to clone
its current Wi-Fi settings to the extender.
Tips:
We recommend that you plug in the extender near your router for Wi-Fi cloning.
Router
1
1
Press the WPS button
for 2 seconds.
2
Within 2 minutes, press the
Wi-Fi Clone button for 1 second.
3
Done.
Wireless Router
Blinks slowly for
Solid on for 5 seconds
WAN
WPS
LAN
about 10 seconds
and then blinks rapidly
Note:
If the Wi-Fi LED still blinks slowly for longer than 30 seconds, unplug the extender and plug
it back in, then try again. Or use “Customize the Extender’s Wi-Fi Settings” on the back instead.
To Next Page
Need help?
General
