©2024 TP-Link
7106510819 REV3.0.0
Plug the extender into a power outlet next to your router. Wait until
its Power LED turns solid on.
Note: For safety, only plug the extender in the direction as shown below.
Power On
Relocate
3
Quick Installation Guide
Range Extender
1
Next to
Router Devices
Halfway
Green: Suitable location
Yellow: Too far from router
1. Plug in the extender about halfway between your router and the Wi-Fi dead
zone. The location you choose must be within the range of your router.
2. Wait for about 2 minutes until the LED turns solid green. If it doesn't,
relocate the extender closer to the router to achieve better signal quality.
Set Up
2
Setup with videos
Scan the QR code, or visit
https://www.tp-link.com/support/setup-video/#range-extenders
and search for the setup video of your model.
Note: RE365 (EU version) is used for demonstration in this guide. Images may dier from your actual product.
Method 3: Via a Web Browser
1. Connect your computer or smartphone to the
extender’s network TP-Link_Extender.
3. Follow web instructions to complete the setup.
2. Visit http://www.tplinkrepeater.net or
http://192.168.0.254 in a web browser. Create a
password to log in.
Method 2: Via the Tether App
1. Get the up-to-date Tether app from the Apple App
Store or Google Play, or simply scan the QR code.
3. Tap the button and select Range Extender.
2. Launch the Tether app and log in with your TP-Link ID.
If you don’t have an account, create one first.
3. Done. You can connect to the extender’s Wi-Fi.
Tether
Scan for Tether
or
Notes:
1. If you cannot find your device, please refer to FAQ > Q1.
2. Due to Tether app updates, your actual user interface
and pathway may differ from those depicted here.
My Devices
No devices found.
Choose Your Device Type
Wireless Router
Gaming Router
Range Extender
2. Within 2 minutes, press the WPS button on the
extender for 1 second, and the LED starts
blinking. Wait for the LED, 2.4G/5G LED to turn
solid on, indicating a successful connection.
4. Follow app instructions to complete the setup. The
LED should turn solid on, indicating successful
connection to your router.
Note: If the LED does not turn solid on, please refer
to FAQ > Q2.
Method 1: Via the WPS Button
1. Activate the WPS function on your router by
pressing the WPS button.
Note: If you don’t know how to do, refer to your router’s user
manual, or you can use other methods to set it up.
The WPS button might
look like one of these:
Extended Network Names:
Router’s network name with _EXT at the end
or
Same as your EasyMesh router (see back for EasyMesh
details)
Passwords:
Same as your router
Blinking Solid On
Solid On
Solid On
Tip: To place the extender for optimal Wi-Fi performance, access extender
settings via the Tether app and go to find Location Assistant, or simply scan
the QR code to visit https://www.tp-link.com/support/faq/3103/.
Enjoy!
· Connect your devices to the extender wirelessly or via an Ethernet cable, then
enjoy the internet. The password of your extended network is the same as your
main router.
· You can also change the extender to Access Point Mode to transform your
existing wired network to a wireless one. For details, see Access Point Mode
(AP Mode) on the back page.
LOG IN
http://www.tplinkrepeater.net
TP-Link_Extender
To Next Page
Need help?
General
