Installation Guide
LED Explanation
Connection
Conguration
TL-R605
Modem
Internet
On: Power on
O: Power o
Power
Flashing: System running normally
On/O: System running abnormally
System
Note: For simplicity, we take TL-R605 as an example throughout this Guide.
© 2020 TP-Link 7106508730 REV1.0.0
SafeStream Gigabit Multi-WAN VPN Router
Option 1: Standalone Mode
Open a web browser and type the default management address
192.168.0.1 in the address eld of the browser, then press the Enter key.
2.
Connect a computer to a LAN port of the router with an RJ45 cable
properly. If your computer is congured with a xed IP, change it to Obtain
an IP address automatically.
1.
For detailed congurations, refer to the User Guide of the router. The guide
can be found on the download center of our ocial website:
https://www.tp-link.com/support/download/.
Create a username and a password for subsequent login attempts and
for security.
3.
Use the username and password set above to log in to the webpage.4.
After a successful login, you can congure the function by clicking the
setup menu on the left side of the screen.
5.
Link/Act and 1000Mbps (for TL-ER7206)
The router supports two conguration options:
Standalone Mode: Congure and manage the router singly.
Controller Mode: Congure and manage the network devices centrally. It is recommended in the large-scale network, which consists of mass devices such as
access points, switches, and gateways.
Note: Use the charger provided in the
package to power on the router.
On: There is a device connected to the port and running at 1000 Mbps.
O: There is no device connected to the port or not running at 1000 Mbps.
On: There is a device connected to the port but not active.
O: There is no device connected to the corresponding port.
Flashing: Transmitting or receiving data.
Router
PC
In Standalone Mode, use a computer to congure and manage the router.
Link/Act (for TL-R605) | SFP WAN (for TL-ER7206)
On: There is a device connected to the port but not active.
O: There is no device connected to the corresponding port.
Flashing: Transmitting or receiving data.
Note: When the router is managed by a controller, congurations of the router will be overriden by the controller.
To Next Page
Need help?
General
