1
Note
If the LEDs display abnormally, please check to see if all the cable
connectors (power adapter and Ethernet cable) are well connected to your
device.
Connect to the Access Point with
the Ethernet cable or via wireless.
The default SSID of the Access
Point is TP-LINK_ XXXXXX. The
XXXXXX is the last 6 characters
of the Access Point’s MAC
address.
Plug the provided power adapter
into the power jack on the back of
the Access Point, and the other
end to a standard electrical wall
socket. Then press the QP1QHH
button to power on the device.
Turn on all of your network devices and then check to see if the LEDs on the
Access Point display normally as the diagram below describes.
Note
If the distance between the outlet and the Access Point is too long to supply
the power, you can refer to the Power over Ethernet (PoE) solution in
Crrgpfkz"C<"Ykvj"RqG"Ugvwr on rcig"350
Uqnkf"nkijv"
Hncujkpi"
Uqnkf"nkijv"qt"hncujkpi"
Hncujkpi" kh" vjg" Yktgnguu"
Tcfkq"hwpevkqp"ku"gpcdngf