18-AC78D1-6
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information
pack upon completion of work.
Condensing Units
These instructions do not cover all variations in systems or provide for every possible contingency to be met in connection with the in-
stallation. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s
purposes, the matter should be referred to your installing dealer or local distributor.
Note: The manufacturer recommends installing only approved matched indoor and outdoor systems. All of the manufac-
turer’s split systems are A.H.R.I. rated only with TXV indoor systems. Some of the benefits of installing approved matched
indoor and outdoor split systems are maximum efficiency, optimum performance and the best overall system reliability.
4TTM3018 through 4TTM3060
Installer’s Guide
Table of Contents
Section 1. Safety .................................................................................................... 2
Section 2. Unit Location Considerations .................................................. 3
Section 3. Unit Preparation .............................................................................. 5
Section 4. Setting the Unit ................................................................................ 5
Section 5. Refrigerant Line Considerations ............................................ 6
Section 6. Refrigerant Line Routing ............................................................ 7
Section 7. Refrigerant Line Brazing ............................................................. 8
Section 8. Refrigerant Line Leak Check .................................................. 10
Section 9. Evacuation ....................................................................................... 11
Section 10. Service Valves .............................................................................. 11
Section 11. Electrical - Low Voltage ........................................................... 12
Section 12. Electrical - High Voltage .......................................................... 14
Section 13. Start Up ........................................................................................... 15
Section 14. System Charge Adjustment.................................................. 16
Section 15. Checkout Procedures and Troubleshooting ................ 24
Section 16. Independent Charge Verification ....................................... 26
To Next Page
Need help?
General
