Need help?Do you have a question about the Trane CenTraVac Duplex CDHF and is the answer not in the manual?
Details about the unit nameplate and its sections.
Breakdown of the chiller model number components and their meaning.
Alphabetical list of acronyms and their definitions used in the manual.
Detailed explanation of the refrigerant cycle in cooling mode for duplex chillers.
Describes components housed in control panels and unit-mounted devices.
Overview of the Tracer CH530 controller, its features, and benefits.
Explains the DynaView™ interface, its screen layout, and navigation.
Details the top-level and sub-level operating modes displayed on the chiller.
Explains how to navigate and use the settings screens for adjustments.
Defines key terms related to the IPC3 protocol and bus management.
Identifies internal control panel devices by schematic designation number.
Illustrates the layout of control panel components and their designations.
Explains the electrical sequence of operation for the chiller's control logic.
Details the logic circuits for UCP and Wye-Delta starters in chiller operation.
Explains how the system handles momentary power losses to protect the motor.
Details how motor currents are monitored for overload and locked rotor protection.
Explains the logic to prevent motor shutdown by limiting compressor current draw.
Monitors evaporator refrigerant temperature to prevent low-temp trips.
Protects the evaporator from freezing by monitoring low refrigerant temperature.
Provides short cycle protection for the motor and starter.
Provides a detailed procedure for daily unit start-up checks and actions.
Outlines the procedures for starting the unit after a period of shutdown.
Provides the procedure for daily unit shutdown and post-shutdown actions.
Describes basic preventive maintenance procedures and recommended intervals.
Lists daily checks for evaporator/condenser pressures and oil tank status.
Recommends completing daily procedures and checks weekly.
Recommends performing all recommended weekly maintenance procedures.
Recommends oil and filter change intervals based on operating hours.
Provides a step-by-step procedure for replacing the oil filter.
Lists various checks like motor winding resistance and tube inspection.
Details lubrication points for vane linkage and operators.
Procedures for handling refrigerant charge, recovery, and system preparation.
Outlines the process for leak testing a chiller with a full refrigerant charge.
Discusses condenser tube fouling and cleaning methods.
Describes the process and recommended frequency for evaporator cleaning.
Steps required to prepare a unit for extended storage.
Procedures to prepare the unit for commissioning.
Detailed checks and tests to be performed before initial startup.
To Next Page
General
