BAS-SVX44A-EN 5
Overview
The Trane™ Touch-screen Programmable Thermostat is for use with conventional Rooftop Units
(RTU) air conditioners and heat pumps. These units are compact, easy to install, configure, and
operate.
This installation and operation manual provides information about the following:
• Specifications and dimensions
• Product features and functions
• Pre-installation requirements
• Installation and wiring
• Power, system tests, and software reset
• Configuration option setup
• Other thermostat functions
• Temperature cycle control
• Other functional components
• Error codes and exceptions
• Troubleshooting
Note: Before beginning installation, visually inspect all parts for obvious defects for damage. All
components are thoroughly inspected before leaving the factory. Any claims for damage
incurred in shipping should be filed immediately with the carrier.
Packaged Contents and Tools
Packaged Contents
Each programmable thermostat ships with the following:
• One (1) Trane Touch-screen Programmable Thermostat
• One (1) Installation/Configuration Instructions (X39641190-01)
• One (1) Setup/Programming Instructions (X39641189-01)
• One (1) bag of:
- Two (2) machine screws
- Two (2) wood screws
- One (1) security screw
- Two (2) wall anchors
- Two (2) terminal blocks; an 8-pin and a 6-pin
Tools
• One (1) 1/8 inch, flat-bladed service screwdriver
• One (1) small Phillips screwdriver
• Level
• Drill
• Hammer
• Wire cutter/stripper
To Next Page
Loading...
Need help?
General
