WALL-MOUNT AIR HANDLERS
2-3TON COOLING/HEAT PUMP
TMM5B0A24M21SAA
TMM5B0B30M21SAA
TMM5B0B36M31SAA
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
Important: This Document is customer property and is to remain with this unit.
Installer’s Guide
Section 1. Features
1.1 Standard Features
1.2 Optional Accessories
•
5, 7.5 and 10 kW SINGLE PHASE ELECTRIC
HEATERS
- Circuit breakers are standard on all single
phase 5,
7.5 and 10 kW heaters.
The TMM5B series wall mount air handler is designed for installation in a closet, utility room, alcove
and can be wall mounted. These versatile units are applicable to air conditioning and heat pump
applications. Field installed electric resistance heaters are available.
• All aluminum coil.
• Blower and coil slide out easily for maintenance.
• Factory-sealed cabinet certified to achieve 2% or
less air leakage rate at 1.0 inch water column.
• Front or bottom return air.
• Painted finish on galvanized steel.
• Sturdy polycarbonate drain pans.
- Air handler has factory installed drain pans and
is shipped for upflow applications only.
• 208/230 VAC operation.
• Multi-speed direct drive blower constant torque
ECM motor with fan-off time delay programming.
• Factory installed R-410A thermal expansion
valve.
• Stud or wall mounting installation.
• Fully insulated cabinet.
• 3/4'' NPT primary and secondary drains.
• AHRI certifird and ETL listed.
18-GF13D1-1A-EN
To Next Page
Need help?
General
