ear
Suspension
i
Inspection
I.
Clean all components and inspect for damage
I
wear to:
rear suspension unit upper and lower
mountings,
lower mounting spacers and '0' rings,
drop link bearings, sleeves and seals.
2.
Renew as necessary.
3,
Check the drop link upper bearings for wear.
Overhaul as necessary (see page
12-10).
4.
Check the drag link bearings for wear. Overhaul
as necessary (see page
12-12).
Installation
1
1.
Locate the rear suspension unit and loosely fit
the upper mounting bolt, spacer and nut.
2.
Position the rear suspension unit reservoir to the
mudguard and secure with the clip.
3.
Pack the drop link bearings with grease and fit
the sleeves.
gael
1.
Drag Link
2.
Drop Link
3.
Drop Link Bearings
4.
Sleeves
4.
Position the spacers on either side of the rear
suspension unit lower mounting with their smaller
outside diameters towards the mounting.
1.
Rear suspension unit
2.
'0'
rings*
3.
Spacers
*
'0'
rings are permanently attached to the
RSU
but
shown detached for identification
5.
Pivot the drag link and drop link into position and
loosely fit the securing bolt
I
nut.
6.
With the weight of the motorcycle on its wheels,
tighten the rear suspension unit upper mounting
to
48
Nm.
7.
Tighten the rear suspension unit lower mounting
to
100
Nm.
8.
Connect the battery, red (positive) lead first.
9.
Fit the seat and rear panels. (see page
16-9).
Service Manual
-
Speed Triple
To Next Page
Loading...
Need help?
General
