General Information
26
Warning Lights
Note:
• When the ignition is switched on, the
instrument warning lights will
illuminate for 1.5 seconds and will
then go off (except those which
remain on until the engine starts, as
described in the following pages).
Direction Indicators
When the direction indicator
switch is pushed to the left or
right, the direction indicator
light will flash on and off at the same
speed as the direction indicators.
Neutral
The neutral warning light
indicates when the transmission
is in neutral (no gear selected).
The warning light will illuminate when
the transmission is in neutral with the
ignition switch in the ON position.
High Beam
When the ignition is switched
on and the headlight dip switch
is set to high beam, the high
beam warning light will illuminate.
Low Fuel
The low fuel indicator will
illuminate when there are
approximately 4.0 litres of fuel
remaining in the tank.
Cruise Control Light
The cruise control can only be
activated when the motorcycle
is travelling at a speed between
30to 100mph (48to 160km/h) and is in
4
th
gear or higher. When activated, the
cruise control light in the tachometer
will be illuminated (see page 53).
1. Cruise control light
Cruise control must only be used
where you can ride safely at a steady
speed.
Cruise control should not be used
when riding in heavy traffic, on roads
with sharp/blind bends or when they
are slippery.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result in
loss of motorcycle control and an
accident.