778-12364A© 2013 11A-B06
Starter
Rope Handle
Blade Control Handle
Wing Nuts
T-Bolts
A. Remove the wing nuts and carriage bolts
securing the upper handle to the lower
handle.
A
Pivot the upper handle
upward.
B. Remove T-bolts from
the handle brackets.
A. Pull upward on
the handle until
the holes in lower
handle line up
with the holes
in the handle
bracket.
A
B
A. Insert the T-bolts removed in Step 1B
through the handle brackets to secure
the handle in place.
A. Hold blade control handle against upper handle.
B. Slowly pull starter rope handle from engine and
slip starter rope into the rope guide.
C. Tighten rope guide wing knob.
D. Use cable tie to secure cables to lower handle.
A
B
C
D
B. Secure upper handle
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
A
B
B
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
To Next Page
Need help?
General
