Troy-Bilt Squall 5521 User Manual

Safety • Assembly • Operation • Tips & Techniques • Maintenance • Troubleshooting • Parts Lists • Warranty
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law
(Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester
for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland,
Ohio 44136-0019.
TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A
READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION
IMPORTANT
OPERATOR’S MANUAL
4/2005
FORM NO. 769-00309C
Snow Thrower Model 5521 — Squall

Troy-Bilt Squall 5521 Specifications

General

Brand	Troy-Bilt
Model	Squall 5521
Category	Snow Blower
Language	English

Summary

Finding and Recording Model Number

Customer Support

Safety Labels

Safe Operation Practices

Training

Instructions for operating the snow thrower safely, covering understanding controls and following guidelines.

Preparation

Steps to prepare the snow thrower and work area for safe and effective operation, including checks and attire.

Snow Thrower Setup

Contents of Carton

Lists all items included in the snow thrower packaging, with part numbers for reference.

Positioning the Upper Handle

Instructions on how to correctly position and secure the upper handle for operation.

Assembling the Discharge Chute

Steps to properly attach and pivot the discharge chute for directing snow flow.

Know Your Snow Thrower

Operation

Before Starting

Crucial pre-operation checks and safety precautions, including attaching the spark plug wire.

Gas and Oil Fill-Up

Instructions for checking and filling the engine's oil and gasoline levels before operation.

To Start Engine

Step-by-step guide on how to start the snow thrower engine outdoors.

Electric Starter

Detailed instructions for using the electric starter, including safety and power connection requirements.

Recoil Starter

Procedure for starting the snow thrower using the manual recoil starter mechanism.

To Stop Engine

Steps to safely shut down the snow thrower engine and disconnect power.

Operating the Snow Thrower

How to adjust chute direction and pitch for effective snow throwing.

Operating Tips

Advice for efficient snow throwing, including overlap, handle pressure, and engine drying.

Adjustments & Maintenance

Shave Plate

Checking and adjusting the shave plate for proper ground contact.

Replacing Shave Plate

Instructions for removing, reversing, and installing a new shave plate.

Control Cable

How to adjust the auger control cable tension for proper engagement.

Carburetor

Reference to engine manual for carburetor adjustment information.

Replacing Belt

Steps for removing and installing the drive belt, including safety precautions.

Engine

Reference to engine manual for all maintenance procedures and checks.

Lubrication

Guidance on lubricating pivot points and springs for smooth operation.

Replacing Auger Paddles

Instructions for replacing worn auger paddles to prevent damage to the unit.

Off-Season Storage

Preparing Engine

Steps to prepare the engine for long-term storage, including oiling the cylinder.

Preparing Snow Thrower

Instructions for storing the snow thrower, including cleaning, rustproofing, and fuel system prep.

Troubleshooting

Customer Support for Troubleshooting

Contact information and guidance for seeking assistance with product issues.

Part List: Snow Thrower

Accessories & Kits

NOTES: