769-07844 P00 04/12
NEED HELP? CALL 1-800-828-5500 IN U.S. OR 1-800–668–1238 IN CANADA
TB2BV EC
2-Cycle
Electric Start Capable
Handheld Blower / Vacuum
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Upper Blower Tube
Removing Unit From Carton
Assemble The Unit
Insert the upper blower
tube into the blower outlet
and turn it clockwise until
it locks into place.
Install the lower blower tube
onto the upper blower tube
and turn it clockwise until it
locks into place.
Starting The Unit
Assemble The Unit
Place the unit on a level
surface. Remove the fuel
cap. Fill the fuel tank.
Replace the fuel cap. Move
the unit at least 30 ft. (9.1 m)
from the fuel container and
the fueling site before
starting the engine.
Crouch in the starting
position.
DO NOT squeeze the
trigger.
Do not squeeze the
trigger. Pull the rope 5
times.
Do not squeeze the
trigger. Move the choke
lever to Position 2.
11 2
Remove all contents from
carton.
5
18 9
3
Starting The Unit
10
11
Need Help?
Call 1-800-828-5500
DIDN’T START?
Repeat the starting instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to the
operator’s manual for additional starting
and troubleshooting information
Mix thoroughly in a separate
fuel can:
– 3.2 fl. oz. of 2-cycle
engine oil
– 1 gallon of fresh
unleaded gasoline (less
than 30 days old)
NOTE: Do not mix directly in
the fuel tank.
4
Starter Rope
On/Off Stop Control
Lower Blower Tube
Trigger
Handle
Cruise Control
Starting The Unit
Fuel Cap
Primer Bulb
Choke Lever
Lower Vacuum Tube
Upper Vacuum Tube
Vacuum Elbow
Vacuum Bag Strap
Cinch Strap
Vacuum Bag
Zipper
Air Filter
Cover
Muffler
Cover
Spark Plug
ASSEMBLY TOOLS REQUIRED:
• Flat-head Screwdriver
1 Gallon 3.2 oz
40:1
Press the primer bulb 10
times, or until fuel is visible.
Move the choke lever to
Position 1.
16 7
5 X
Squeeze the trigger, or
press down the cruise
control, and allow the unit to
warm up for 30-60 seconds.
Continue to squeeze the
trigger. Move the choke
lever to Position 3. Warm
the unit for an additional 60
seconds. The unit may be
used during this time.
113 14
Do not squeeze the
trigger. Pull the rope 3-5
times to start the engine.
12
3-5 X
10 X
Primer
Bulb
Choke Lever
English — Page 1Español — Page 7
Operator’s Manual
To Next Page
Need help?
General
