Quick Installation Guide
Printer Overview
Note:
The interface picture here is for reference only. Please refer to the product specification for the interfaces
availability.
Loading the Ribbon
(1) Open the printer right side cover.
Install the ribbon and paper core
onto ribbon supply spindle and
ribbon rewind spindle.
(2) Push print head release lever to
open print head mechanism.
(3) Thread ribbon under the ribbon
guide bar and through ribbon
sensor slot. (Please refer to
“Loading path for ribbon” as
following fig.)
(4) Stick ribbon onto ribbon rewind
paper core, keeping the ribbon flat
and wrinkle-free.
(5) Wind the ribbon rewind spindle
clockwise roughly 3~5 circles until
ribbon is smooth, properly stretched
and wrinkle-free.
(6) Close the print head mechanism
by pushing the both sides of print
head mechanism. Make sure the
latches are engaged properly.
* Loading path for ribbon
Print Head Pressure
Adjustment Knobs
Fan-fold Paper
Entrance Chute
Centronics
Interface
(Option)
USB Host
Interface
(Option)
Ethernet Interface
(Option)
To Next Page
Need help?
General
