Self-test
Printer will print the printer configuration after gap/black mark sensor calibration. Self-test
printout can be used to check if there is any dot damage on the heater element, printer
configurations and available memory space.
Printer model name & Main board firmware version
Printer serial number
Printed mileage
Main board firmware checksum
Serial port setting
Code page
Country code
Print speed
Print darkness
Label size (width, height)
Black mark or gap size (vertical gap, offset)
Sensor sensitivity
Ethernet settings information (option)
File management information
Print head test pattern
To Next Page
Loading...
Need help?
General
