Ubee UBC1301-AA00 Quick Installation Guide

!
•
DEVICE WALL MOUNT INSTRUCTIONS
You can mount the UBC1301-AA00 on a wall using the 2 mounting
brackets on the side of the device. Two round or pan head screws
are recommended. See the figure below for measurements.
www.ubeeinteractive.com
2
Label
Size in Millimeters (mm)
A
6.65 +/- 0.35
B
1.9 +/- 0.15
C
19.0 +/- 1.2
UBC1301-AA00 Quick Installation Guide
NOTE to CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV systems installer's
attention to section 820-93 of the National Electric Code, which
provides guidelines for proper grounding and in particular,
specify that the Coaxial cable shield shall be connected to
grounding system of the building, as close to the point of cable
entry as practical.
Note: The screws should protrude from the wall so you can fit
the device between the head of the screws and the wall. If
you install the screws in drywall, use hollow wall anchors to
ensure the unit does not pull away from the wall due to
prolonged strain from the cable and power connectors.
2.
Mount the device on the wall.
To mount the device on a wall:
1. Install the 2 screws horizontally on the wall 153 mm (5.9
inches apart.

Ubee UBC1301-AA00 Specifications

General

Brand	Ubee
Model	UBC1301-AA00
Category	Gateway
Language	English