UNI-T UTG962E User Manual

Table of Contents
Copyright Information
Table of Contents —
Chapter 1 Safety Information
1.1 Safety Terms and Symbols
1.2 General Safety Overview -—
Chapter 2 Introduction
2.1 Main Feature —
2.2 Output Feature:
2.3 Panels and Buttons Introduction
2.3.1 Front Panel
2.3.2 Left and Right Panel
2.3.3 Function Interface
3.1 General Inspection —
3.1.2 Check Accessories
3.1.3 Inspect the Device
3.2 Basic Waveform Output —
3.2.1 Set Output Frequency -
3.2.2 Set Output Amplitude
3.2.3 Set DC Offset Voltage -
3.2.4 Set Phase
3.2.5 Set Pulse Wave Duty Ratio
3.2.6 Set Ramp Symmetry
3.2.7 Set DC Voltage -
3.2.8 Set Noise Wave
3.3 Utility Settings
3.3.1 Channel Settings —
3.3.2 Frequency Counte
3.3.3 System Settings -—
Chapter 4 Advanced Applications
4.1 Generate Modulation Waveform —
4.1.1 Amplitude Modulation (AM)
4.1.2 Phase Modulation (PM) —
4.1.3 Frequency Modulation (FM
4.1.4 Frequency Shift Keying (FSK)
4,2 Output Frequency Sweep Waveform -
4.2.1 Select Frequency Sweep
4.2.2 Set Starting and Stop Frequency —
4.2.3 Frequency Sweep Mode
4.2.4 Frequency Sweep Time -
4.2.5 Comprehensive Example
4.3 Output Arbitrary Wave
4.3.1 Enable Arbitrary Wave Function
4.3.2 Select Arbitrary Wave -
Chapter 5 Fault Handling -—-
Chapter 6 Service and Support
6.1 Outline of Warranty
6.2 Contact Us —
Appendix A: Factory Reset State —
Appendix B: Performance Index
Appendix C: List of Accessories —
Appendix D: Maintenance and Cleaning

UNI-T UTG962E Specifications

General

Brand	UNI-T
Model	UTG962E
Category	Portable Generator
Language	English