UNIQUE UGP 3
6
5. Keep the safety device control (D) depressed for a further 10-15 seconds.
6. Release the safety device control (D) and again check to see that the flame is
alight.
7. Adjust the thermostat knob (E) to desired temperature setting after 6 to 8
hours of operation.
8. To terminate gas operation, turn selector switch (F) to either AC, DC or
OFF position.
9. To change the battery in the electronic ignition, turn button (A) to the left to
expose the battery, remove AAA battery and replace with new one (positive
facing outwards), replace the knob and turn to the right to close.
Shut Down Procedure – LP Gas
A. Turn selector knob (F) to the “AC, DC or OFF” position.
B. Shut the gas off at the LP-gas supply cylinder when the appliance is not in use.
C. If the refrigerator will not be in operation for a period of weeks, it should be emptied,
defrosted, cleaned and the doors left open. The ice tray should also be dried and kept
outside the cabinet.
110V Operation
1. Make sure that the gas valve is turned off at the tank.
2. Ensure the electrical cord is plugged into a grounded outlet.
3. Turn the selector switch (F) to AC position. AC power indicator will illuminate.
4. Adjust the thermostat knob to desired temperature setting after 6 to 8 hours of
operation.
12V DC Operation
1. If 110 Volts or LP gas is not available, the refrigerator can work with DC12V
(3-Way models only).
2. Make sure that you turn the main power switch (F) to “DC” position. Then
you can connect the 12VDC power to the terminal block which is available
in the rear bottom part of the refrigerator.
3. DC operation is not as efficient as LP Gas or AC operation. DC electric
should not be used to initially cool the refrigerator. Only use DC when the
To Next Page
Loading...
Need help?
General
