Learn more
Quick Start Guide
• DON’T operate any tube amp without
an output load (such as OX or a speaker)
• DON’T use OX with amps exceeding
150 Watts output
• DON’T expose OX to moisture or
liquids (no frosty beverages on top!)
• DON’T cover OX’s air vents
• DON’T connect anything other than
a guitar speaker cabinet to OX's
high-power SPEAKER output
TO AVOID GEAR MELTDOWN:
CAUTION!
RIG
Choose from six complete guitar cabinet
/ mic / room / effect setups. RIG presets
are easily customized with OX software.
LINE OUT
Adjusts the signal
level at OX’s
LINE/MON outputs.
HEADPHONE
Adjusts the volume of
stereo headphones
connected here.
ROOM
Instant access to mic’d studio ambience
and air. ROOM settings are easily
customized with OX software.
SPEAKER VOLUME
Adjusts the volume of the guitar cabinet connected
to OX’s rear panel. At position 0, the guitar speaker
is OFF for silent operation. Note:
RIG and ROOM
knobs don't affect the speaker output.
Crank Up
Important: Power off your tube amp before connecting or disconnecting guitar speaker cables
Connect OX’s included power supply
Set OX’s rear panel IMPEDANCE knob to match your amp’s output impedance
Connect a ¼” speaker cable between your amp’s speaker output and OX's
red FROM AMPLIFIER input on the rear panel. (See reverse side for OX output connections.
)
➊
➋
➌
➍
AMP SPEAKER OUTPUT
Set Up
Set OX’s SPEAKER VOLUME,
LINE OUT, and HEADPHONE
knobs to minimum position
Power on OX with the rear
panel POWER switch
Power on your guitar amp
Adjust your amp controls
to make it sound sweet
➎
➏
➐
➑
Start Up
Shielded Cable
•
One larger center wire
(2 center wires if balanced TRS)
•
Shield around center wire(s)
Use only ¼" mono unshielded
speaker cables for OX’s
high-power FROM
AMPLIFIER
and TO SPEAKER connections
Speaker Cable
• Two wires, same size
• No shield around wires
Know Your
Cables
To Next Page
Need help?
General
