Please check to see that all parts are included in
your package. Contact your dealer if any
product parts are missing or damaged. Send in
your Warranty Card today to ensure that you are
registered.
Assembly & Testing
For correct operation, and to ensure prevention
of electrical shock, follow these directions for
assembly.
1. Place your lifting cushion on an appropriate
chair.
2. Insert the power lever(s) over the steel
prongs on either side of the lifting cushion at
the front. Angle the levers towards the front
as shown in the photo below. The levers
should clip easily into place.
3
Before using your UPEASY Power Seat, please:
1. Check package contents to ensure that all
components are enclosed and in good
condition (see picture below).
2. Test the lifting cushion to ensure that it is in
working order.
Check Package Contents
Your UPEASY Power Seat comes with the
following components:
• UPEASY Power Seat (in the flat position)
with power cord
• Two power levers
• This Users Guide and your Warranty
Registration Card
Before Using your Power Seat
www.upeasy.com
Specifications
CSA & C/US Approved
US Patent #5,316,370. Other US, European and
International patents pending.
Seat Dimensions:
Length: 19"/48 cm
Width: 16"/41 cm
Cover: 100% polyester.
Seat Height:
Lifted: 10"/25 cm
Flat (When Seated): 2"/5 cm
Weight:
12 lbs/5.4 kg
Capacity:
For users weighing up to 300 lb/136 kg
Power Supply:
120 VAC 60 Hz 0.6 A
Cord Length:
10 ft/3.0 m
Power Cord
Two (2) power
levers
Lifting
cushion in
flattened
position
To Next Page
Loading...
Need help?
General