4-57
Operation Panel
This new network address section (originally part of the host address) made possible by the subnet mask is referred to as
the subnet address.
1 In the IPv4 Setting menu, press or to select Subnet Mask.
2 Press [OK]. The Subnet Mask screen appears.
3 Use the numeric keys or press or to set the subnet mask.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing or .
Use and to move the position being entered, which is shown
highlighted.
4 Press [OK]. The subnet mask setting is stored and the IPv4
Setting menu reappears.
Default Gateway (Gateway setting)
Gateway generally refers to a protocol conversion device used to allow networks with differing protocol systems to
interconnect.
For example, a "Gateway" device is required to connect a different closed network (using its own protocols) to the open
Internet (using TCP/IP).
By installing a gateway, the communications protocols and data display modes on different networks can be made
compatible.
On TCP/IP networks, the term gateway is used to refer to routers.
1 In the IPv4 Setting menu, press or to select Default
Gateway.
2 Press [OK]. The Default Gateway screen appears.
3 Use the numeric keys or press or to set the default gateway.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing or .
Use and to move the position being entered, which is shown
highlighted.
4 Press [OK]. The default gateway is stored and the IPv4 Setting
menu reappears.
Note When you enter the subnet mask, be sure to set the DHCP setting to Off.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
